ESP-WROOM-02

ESP-WROOM-02

Moduli WIFI Espressif
Produttore: Espressif

ESP-WROOM-02 is a low-power 32-bit MCU Wi-Fi module, based on the ESP8266 chip.
TCP/IP network stacks, 10-bit ADC, and HSPI/UART/PWM/I2C/I2S interfaces are all embedded in this module.
ESP-WROOM-S2 uses a 2 MB SPI flash connected to HSPI, working as SDIO/SPI slave, with the SPI speed being up to 8 Mbps.

Fully Certified
Certified by Wi-Fi Alliance, SRRC, FCC, CE ( RED ), TELEC, IC & KCC
Compliant with RoHS, Halogen Free, REACH & CFSI
HTOL, ESD-HM, MSL, µHAST, HTSL
Output Power: +22dBm peak power in the FCC certification

Wi-Fi:
-Rf certification FCC/CE/TELEC/KCC/SRRC/IC/NCC
-Wi-Fi protocols 802.11 b/g/n
-Frequency range 2.4 GHz - 2.5 GHz (2400M - 2483.5M)

Hardware:
-Peripheral interface UART/HSPI/I2C/I2S/IR Remote Control
GPIO/PWM
-Operating voltage 2.7V - 3.6v
-Operating Current Average: 80mA
-Minimum current delivered 500mA by power supply
-Operating temperature range -40°C - 85°C
-Storage temperature -40°C ~ 85°C
-Package size
Software: (18±0.2) mm x (20±0.2) mm x (3±0.15) mm
-Wi-Fi mode Station/SoftAP/SoftAP + Station
-Security WPA/WPA2
-Encryption WEP/TKIP/AES
-Firmware upgrade UART Download/OTA (via network)/Download and write firmware via host
-Software development Supports Cloud Server Development/SDK for custom firmware development
-Network protocols IPv4, TCP/UDP/HTTP/FTP
-User configuration AT Instruction Set, Cloud Server, Android/iOS app

ESP-WROOM-02 with high temperature range option (-40°C ~ 125°C) is available for custom order.

ESP-WROOM-02 currently integrates a 2-MB SPI flash. ESP-WROOM-02 supports these SPI modes: Standard SPI, DIO (Dual I/O), DOUT (Dual Output), QIO (Quad I/O) and QOUT (Quad Output).

ESP-WROOM-02 uses a 26-MHz crystal oscillator. The accuracy of the crystal oscillator should be ±10 PPM.
When using the download tool, please select the right type of crystal oscillator. In circuit design, capacitors C1 and C2 which connect to the earth are added to the input and output terminals of the crystal oscillator respectively. The values of the two capacitors can be flexible, ranging from 6 pF to 22 pF, however, the specific capacitive values depend on further testing of, and adjustment to, the overall performance of the whole circuit.
Normally, the capacitive values of C1 and C2 are within 10 pF for the 26-MHz crystal oscillator.

Per accedere alla documentazione è necessario effettuare l'accesso
Password dimenticata? Clicca qui
Non sei ancora registrato? Clicca qui